Step 11: Secure the rack and shelves

Secure the rack and shelves to make a wine hutch
Photo: Ryan Benyi
«»
Set the wine-rack insert in the hutch, and set a shelf above it. Nail through the sides of the box and into the edges of the shelf with 1½-inch nails to secure it. Do not nail into the wine-rack insert—you want to allow for slight movement. Mark the location of the remaining shelves, and nail them in place.
Ask TOH users about Wetbars

Contribute to This Story Below

    Tools List

    • Rafter Square
      rafter square
    • circular saw
      circular saw
    • straight edge
      straightedge
    • hand clamps
      clamps
    • miter saw
      miter saw
    • pneumatic brad nailer
      pneumatic nailer
    • drill
      drill/driver
    • 1/4-inch drill bit
      ¼-inch drill bit
    • combination square
      combination square
    • jigsaw
      jigsaw

    Shopping List

    1x15 edge-glued panels. Get four 6-footers for the sides and shelves, one 3-footer for the top.

    ¼-inch lauan for the back. Get one 4-by-8-foot sheet.

    1x3 for cleats. Get 3 feet.

    -inch square dowels for the glass rack. Get two 3-footers.

    x3 lattice for the glass rack. Get two 3-footers.

    3¼-inch baseboard molding. Get one 6-footer.

    9/16x3-inch crown molding. Get one 6-footer.

    2x4 for crown backing. Get 3 feet.

    1x2. Get two clear-pine, 6-footers.

    1x5. Get one clear-pine, 8-footer.

    1½-inch and -inch 18-gauge brad nails

    1¼-inch drywall screws.

    wood glue.

    120-grit sandpaper