Step 7: Bevel the parts for the wine rack

Bevel the parts for the wine rack to make a wine hutch
Photo: Ryan Benyi
«»
Clamp a rack piece with one end overhanging your work surface. Adjust the blade on your circular saw to 45 degrees and bevel the end, as shown. Reposition the piece and bevel the other end at an opposing angle. Repeat the process on the other piece.
Ask TOH users about Wetbars

Contribute to This Story Below

    Tools List

    • Rafter Square
      rafter square
    • circular saw
      circular saw
    • straight edge
      straightedge
    • hand clamps
      clamps
    • miter saw
      miter saw
    • pneumatic brad nailer
      pneumatic nailer
    • drill
      drill/driver
    • 1/4-inch drill bit
      ¼-inch drill bit
    • combination square
      combination square
    • jigsaw
      jigsaw

    Shopping List

    1x15 edge-glued panels. Get four 6-footers for the sides and shelves, one 3-footer for the top.

    ¼-inch lauan for the back. Get one 4-by-8-foot sheet.

    1x3 for cleats. Get 3 feet.

    -inch square dowels for the glass rack. Get two 3-footers.

    x3 lattice for the glass rack. Get two 3-footers.

    3¼-inch baseboard molding. Get one 6-footer.

    9/16x3-inch crown molding. Get one 6-footer.

    2x4 for crown backing. Get 3 feet.

    1x2. Get two clear-pine, 6-footers.

    1x5. Get one clear-pine, 8-footer.

    1½-inch and -inch 18-gauge brad nails

    1¼-inch drywall screws.

    wood glue.

    120-grit sandpaper