Step 9: Cut the Dowels Flush

cutting the dowels with a flush-cut saw
Photo: Ryan Benyi
«»
Using a small flush-cutting saw, cut the ends of the dowels even with the face of the boards. Using a sanding block, hand-sand the corners of the box, first with 180-grit paper, then with 220 grit, until they're smooth.
Next

Related Content

Ask TOH users about Storage
Discuss

Contribute to This Story Below

Add Comment

    More in Living Spaces

    Tools List

    Close
    • miter saw
      Miter saw
    • bar clamp
      36-inch bar clamps. At least three
    • finish hammer
      Hammer
    • belt sander
      Belt sander
    • random orbit sander
      Random-orbit sander
    • combination square
      Combination square
    • jigsaw
      Jigsaw
    • brad nailer
      Brad nailer
    • drill
      Drill/driver
    • TruFit step bit
      Miller 2x TruFit step drill bit
    • flush cut saw
      Flush-cutting saw
    • circular saw
      Circular saw
    • multi-bit screwdriver
      Screwdriver

    Shopping List

    Close
    1. Red oak 1x4s to build the box. Get six 8-footers.

      2. Red oak 1x6s Get two 6-footers for the base and one 8-footer for the lid.

      3. ½-inch oak plywood for the floor. Get a 2-by-4-foot sheet.

      4. Miller 2x dowels in black walnut. Go to Miller Dowel Company.

      5. Torsion hinges

      6. 1-inch brad nails

      7. 1-inch deck screws

    8. 1½-inch deck screws

    9. 80-grit, 180-grit, and 220-grit sandpaper

    10. Stain and finish of your choice

    11. Wood glue