Step 8: Insert the Dowels

inserting the glued dowels into the pilot holes
Photo: Ryan Benyi
«»
Apply wood glue to the dowels and insert them into the pilot holes. Use a hammer to tap them fully in place. Install the dowels on the adjacent side of the corner in the same way. Then install the dowels at the other three corners.
Ask TOH users about Storage

Contribute to This Story Below

    Tools List

    • miter saw
      Miter saw
    • bar clamp
      36-inch bar clamps. At least three
    • finish hammer
      Hammer
    • belt sander
      Belt sander
    • random orbit sander
      Random-orbit sander
    • combination square
      Combination square
    • jigsaw
      Jigsaw
    • brad nailer
      Brad nailer
    • drill
      Drill/driver
    • TruFit step bit
      Miller 2x TruFit step drill bit
    • flush cut saw
      Flush-cutting saw
    • circular saw
      Circular saw
    • multi-bit screwdriver
      Screwdriver

    Shopping List

    1. Red oak 1x4s to build the box. Get six 8-footers.

      2. Red oak 1x6s Get two 6-footers for the base and one 8-footer for the lid.

      3. ½-inch oak plywood for the floor. Get a 2-by-4-foot sheet.

      4. Miller 2x dowels in black walnut. Go to Miller Dowel Company.

      5. Torsion hinges

      6. 1-inch brad nails

      7. 1-inch deck screws

    8. 1½-inch deck screws

    9. 80-grit, 180-grit, and 220-grit sandpaper

    10. Stain and finish of your choice

    11. Wood glue