Step 7: Attach the edge strips to the tabletop frame pieces

attach the lip pieces to the frame pieces while building a display coffee table
Photo: Ryan Benyi
«»
Apply wood glue to the 1x1 edge strips and lay them flat on their corresponding frame pieces, flush at the outer edges and mitered ends. Using the pneumatic nail gun, attach the edge strips to the frame pieces using 1-inch nails.
Ask TOH users about Furniture

Contribute to This Story Below

    Tools List

    • miter saw
      Miter saw
    • jigsaw
      Jigsaw
    • drill
      Drill/driver fitted with a countersink drill bit
    • pneumatic finish nailer
      Pneumatic nail gun

    Shopping List

    1. ½-inch plywood to make the floor. Get a 24-by-48-inch piece.

    2. Baseboard to make the tabletop fame. Get two 8-foot boards.

    3. 1x5 to make the apron. Get two 8-foot boards.

    4. 1x1 to make the cleats and the lip of the tabletop frame. Get three 8-foot boards.

    5. Table legs. Get four.

    6. Acrylic sheet. Get a piece at least 30 by 60 inches. 7. 1-inch nails

    8. 2-inch nails

    9. 1 ¼-inch screws

    10. 2-inch screws

    11. Permanent marker

    12. Wood glue

    13. A cyanoacrylate glue, such as Super Glue