Step 11: Put Up the Remaining Panels

sponging the back of another Lincrusta wainscot panel
Photograph: Kolin Smith
«»
Keep installing panels as described. To make cuts at receptacles, measure from the level line and plumb edge of the last panel installed, transfer these marks to the next panel, and carefully cut away the material. Allow the installed panels to dry for 24 hours.
Next

Related Content

Ask TOH users about Wainscoting
Discuss

Contribute to This Story Below

Add Comment

    More in Molding & Carpentry

    Tools List

    Close
    • four-foot level
      4-foot level
    • Pencil
    • utility knife
      Breakaway utility knife with extra blades
    • 12-inch stainless steel ruler
      Metal ruler or straightedge
    • wallpaper smoother
      Smoothing tool for liner
    • j-roller
      Smoothing roller for panels
    • Natural-bristle chip brush
      4-inch chip brush for adhesives
    • synthetic brush
      2½-inch angled paintbrush
    • paintroller
      Roller frame with ½-inch-nap covers
    • grout sponge
      Sponge
    • hardboard
      Piece of hardboard that's at least 1 inch taller than base molding
    • caulk gun
      Caulk gun
    • eye goggles
      Safety goggles
    • miter saw
      Miter saw for chair rail
    • pneumatic brad nailer
      Pneumatic brad nailer gun for chair rail

    Shopping List

    Close
    Lincrusta Available through Lee Jofa, 800-453-3563

    Kraft paper

    Painter's tape

    Lint-free cloths

    Heavy-duty wallpaper liner

    Premixed vinyl wallpaper adhesive

    Clay-based adhesive for panels

    Odorless mineral spiritsLatex gloves

    Vinyl or acrylic adhesive caulk

    Universal acrylic primer-sealer

    Latex paint. Get an eggshell base color and a matte highlight color.

    2-inch brad nails for chair rail

    Wood filler for chair rail

    Fine-grit sandpaper for chair rail