Photo: Renna Bammi
«»
Sand the ledges and base assembly with 120-grit sandpaper. Paint all pieces and let dry.
Step 10: Sand and Paint the Wood Pieces
Introduction
Overview
Step 1
Cut the Ledges
Step 2
Mark Hole Locations for the Spacers
Step 3
Drill the Recesses for the Spacers
Step 4
Transfer the Hole Locations
Step 5
Drill the Holes
Step 6
Cut the Base and the Feet
Step 7
Attach Bottommost Ledge to the Base and Add the Feet
Step 8
Cut the Spacers
Step 9
Lay Out the Pieces
Step 10
Sand and Paint the Wood Pieces
Step 11
Assemble the Pieces
Step 12
Thread the Collar
More in Plumbing, HVAC & Electrical
Tools List
-
Pipe cutter
-
Miter saw
-
Circular saw
-
Finishing nail
-
Hammer
-
Drill/driver
-
⅝-inch paddle bit
-
⅜-inch drill bit
-
Paintbrush
-
Random Orbit Sander
Shopping List
Hollow metal curtain rod
9-by-12-inch piece of ½-inch plywood
1x6 lumber:
1x3 lumber:
Threaded wire rod:
Lamp cord
Wood glue
1-inch screws
120-grit sandpaper
Paint
at least 48 inches long.
9-by-12-inch piece of ½-inch plywood
for the base.
1x6 lumber:
Buy at least 4 feet to make the ledges.
1x3 lumber:
Buy at least 12 inches to make the feet.
Threaded wire rod:
Buy sections to make a rod at least 60 inches long to house the lamp cord.
Lamp kit:Buy one that has a harp, bushing, collar, lamp nut, and lamp cord.
Lamp cord
Wood glue
1-inch screws
to build the C-shaped assembly and to attach the bottommost ledge to the base.
Wood putty120-grit sandpaper
Paint
Contribute to This Story Below