Step 10: Cap the Box

Mark Powers attaches the frame for the top of the x-mas tree box stand
Photo: Mark Weiss
«»
Glue and nail four 1x4 pieces with mitered corners on top of the supports you just made. These will form the top edge of the box.
Next

Related Content

Ask TOH users about Trees & Shrubs
Discuss

Contribute to This Story Below

Add Comment

    More in Yard & Garden

    Tools List

    Close
    • jigsaw
      Jigsaw, circular saw, or handsaw to cut plywood
    • wire cable snips
      Tin snips
    • pneumatic pin gun
      Pneumatic pin nailer
    • miter saw
      Miter saw to fit cap
    • combination square
      Combination square to lay out measurements and marks
    • 30-foot tape measure
      Tape measure
    • one-and-a-half inch paintbrush
      1½-inch paintbrush
    • gloves
      Protective gloves

    Shopping List

    Close
    1. 1x1 Get one 8-foot length.

    2. 1x2 Get one 8-foot length.

    3. ¼-inch plywood Get a half sheet and it cut into five pieces: four for the box sides and one for the box's bottom.

    4. ⅝-inch nails for tacking in plywood.

    5. 1-inch nails for fastening 1x material.6. Wood glue

    7. Tin ceiling panel

    8. Vinyl adhesive caulk

    9. 1x4 Get one 6-foot length.

    10. 120-grit sandpaper

    11. Latex primer

    12. Latex paint in a color of your choice