Photo: Mark Weiss
«»
Create a bottom rail for the box by cutting a 1x2 strip to fit between each pair of legs. Nail to the exterior of each panel, and repeat on all sides.
Step 6: Trim the Bottom of the Panels
Introduction
Step 1
Construct the Legs
Step 2
Start Shaping the Box
Step 3
Complete the Body
Step 4
Support the Bottom of the Box
Step 5
Attach the Box's Bottom Panel
Step 6
Trim the Bottom of the Panels
Step 7
Prepare the Tin
Step 8
Insert the Tin
Step 9
Add Supports to the Top Interior of the Box
Step 10
Cap the Box
Step 11
Finish the Piece
More in Yard & Garden
Tools List
-
Jigsaw, circular saw, or handsaw to cut plywood
-
Tin snips
-
Pneumatic pin nailer
-
Miter saw to fit cap
-
Combination square to lay out measurements and marks
-
Tape measure
-
1½-inch paintbrush
-
Protective gloves
Shopping List
1. 1x1 Get one 8-foot length.
2. 1x2 Get one 8-foot length.
3. ¼-inch plywood Get a half sheet and it cut into five pieces: four for the box sides and one for the box's bottom.
4. ⅝-inch nails for tacking in plywood.
5. 1-inch nails for fastening 1x material.6. Wood glue
7. Tin ceiling panel
8. Vinyl adhesive caulk
9. 1x4 Get one 6-foot length.
10. 120-grit sandpaper
11. Latex primer
12. Latex paint in a color of your choice
2. 1x2 Get one 8-foot length.
3. ¼-inch plywood Get a half sheet and it cut into five pieces: four for the box sides and one for the box's bottom.
4. ⅝-inch nails for tacking in plywood.
5. 1-inch nails for fastening 1x material.6. Wood glue
7. Tin ceiling panel
8. Vinyl adhesive caulk
9. 1x4 Get one 6-foot length.
10. 120-grit sandpaper
11. Latex primer
12. Latex paint in a color of your choice
Contribute to This Story Below