Step 9: Size the Blocking

man sizing blocking for wall niche installation
Photo: Laura Moss
«»
Measure the hidden space between the edge of the opening and the nearest covered stud, on all sides. You'll need to screw blocking to the nearest studs so that it sits flush with the edges of the opening and provides a surface for adhering the niche. Cut the 2x4 blocking pieces to size using a circular saw.
Next

Related Content

Ask TOH users about Cabinets & Shelving
Discuss

Contribute to This Story Below

Add Comment

    More in Interior

    Tools List

    Close
    • utility scissors
      Utility scissors
    • studfinder
      Stud finder
    • straightedge guide
      Straightedge, to mark cut lines between the lath pieces
    • utility knife
      Utility knife, to score the drywall
    • flat prybar
      Small pry bar
    • reciprocating saw
      Reciprocating saw, to cut any lath and plaster and to remove any obtrusive studs
    • circular saw
      Circular saw, to cut the 2x4 blocking
    • drill
      Drill/driver, fitted with a 1⁄8-inch drill bit
    • caulk gun
      Caulk gun
    • paintbrush
      Paintbrush

    Shopping List

    Close
    1. Niche
    Choose a dense polyurethane niche in a design that mimics surrounding moldings.

    2. Cardboard
    to create a template.

    3. Pole system
    (or painter's tape) to hold the plastic sheeting in place.4. Plastic sheeting

    5. Painter's tape
    to secure plastic around work window.

    6. Adhesive caulk

    7. Paint