Photo: Wendell Webber
«»
On one side of each frame, attach a utility pull with the screws provided. When the legs are folded up, the handle will let you take your fun on the road.
Step 8: Attach the handles
Introduction
Overview
Step 1
Outline and cut out the holes
Step 2
Cut 2x4 frames and legs
Step 3
Position the frames
Step 4
Assemble the frames and decks
Step 5
Tape off the design
Step 6
Paint the design
Step 7
Remove the tape
Step 8
Attach the handles
Step 9
Bolt the legs to the frames
More in Landscaping
Tools List
-
Jigsaw fitted with scroll blade (for plywood) and aggressive blade (for lumber)
-
Drill driver fitted with ¼-inch and ⅜-inch drill bits
-
Compass
-
Utility knife
-
Plastic putty knife to seal the painter's tape
Shopping List
½-inch birch-veneer plywood
2x4s Get four 8-foot boards
⅜-by-3½-inch carriage bolts, washers, and nuts to attach the legs
1-inch trim-head screws to attach the top
3-inch deck screws to assemble the frame
Wood glue
6½-inch utility pulls Get two Wood filler
Stain-blocking white primer
Spray paint
Painter's tape
Spray polyacrylic
220-grit sandpaper
6-by-6-inch 16-ounce beanbags Get eight
2x4s Get four 8-foot boards
⅜-by-3½-inch carriage bolts, washers, and nuts to attach the legs
1-inch trim-head screws to attach the top
3-inch deck screws to assemble the frame
Wood glue
6½-inch utility pulls Get two Wood filler
Stain-blocking white primer
Spray paint
Painter's tape
Spray polyacrylic
220-grit sandpaper
6-by-6-inch 16-ounce beanbags Get eight
Contribute to This Story Below