Photo: Wendell Webber
«»
Saw the 2x4s for the stands and uprights to length according to the cut list.
Step 1: Cut the pieces
Introduction
Overview
Step 1
Cut the pieces
Step 2
Drill holes for the rungs
Step 3
Assemble the stand
Step 4
Paint all the pieces
Step 5
Bolt the upright to the legs
Step 6
Insert the rungs
Step 7
Drill a hole through each golf ball
More in Landscaping
Tools List
-
Miter saw
-
Drill driver fitted with 1-inch paddle bit and ¼-inch drill bit
-
Paintbrushes
-
Flat-head screwdriver
-
Utility scissors
-
Pull saw
Shopping List
1-inch dowels Get six at 36-inch lengths
2x4s Get two 8-foot boards
Golf balls Get at least 12
3/16-inch twisted nylon rope Get a 10-foot rope
Stain-blocking white primer Get 1 quart Spray paint in at least four colors
Two ¼-by-4-inch carriage bolts
Two ¼-inch washers
Two ¼-inch wing nuts
3-inch deck screws
2x4s Get two 8-foot boards
Golf balls Get at least 12
3/16-inch twisted nylon rope Get a 10-foot rope
Stain-blocking white primer Get 1 quart Spray paint in at least four colors
Two ¼-by-4-inch carriage bolts
Two ¼-inch washers
Two ¼-inch wing nuts
3-inch deck screws
Contribute to This Story Below