Photo: Kristine Larsen
«»
Apply glue to the backs of the trim pieces, and adhere them to the front and sides of the frame. Use clamps to hold the molding in place while the glue cures.
Step 6: Adhere the Molding
Introduction
Step 1
Build a Plywood Frame
Step 2
Attach the Bottom of the Frame
Step 3
Add Drainage
Step 4
Determine Molding Lengths
Step 5
Make the Cuts
Step 6
Adhere the Molding
Step 7
Secure with Nails
Step 8
Seal the Finish
Tools List
-
Circular saw
-
Hammer and nailset
-
Clamps
-
Drill driver fitted with a ½-inch paddle bit
-
Miter saw
-
Gloves
-
Mask
-
Goggles
Shopping List
1. 6- or 8-inch salvaged baseboard or casing
2. Plastic planter
The planter can be shallower than the window box but should match it in length.
3. Water-resistant wood glue
4. ½-inch exterior plywood
Get a 2-by-2-foot piece.
5. 6d finish nails
6. Clear spar urethane
2. Plastic planter
The planter can be shallower than the window box but should match it in length.
3. Water-resistant wood glue
4. ½-inch exterior plywood
Get a 2-by-2-foot piece.
5. 6d finish nails
6. Clear spar urethane
Contribute to This Story Below