Photo: Kristine Larsen
«»
Use a miter saw for angled corners where the molding pieces intersect. Make straight cuts at the back, where the molding will rest against the house.
Step 5: Make the Cuts
Introduction
Step 1
Build a Plywood Frame
Step 2
Attach the Bottom of the Frame
Step 3
Add Drainage
Step 4
Determine Molding Lengths
Step 5
Make the Cuts
Step 6
Adhere the Molding
Step 7
Secure with Nails
Step 8
Seal the Finish
Tools List
-
Circular saw
-
Hammer and nailset
-
Clamps
-
Drill driver fitted with a ½-inch paddle bit
-
Miter saw
-
Gloves
-
Mask
-
Goggles
Shopping List
1. 6- or 8-inch salvaged baseboard or casing
2. Plastic planter
The planter can be shallower than the window box but should match it in length.
3. Water-resistant wood glue
4. ½-inch exterior plywood
Get a 2-by-2-foot piece.
5. 6d finish nails
6. Clear spar urethane
2. Plastic planter
The planter can be shallower than the window box but should match it in length.
3. Water-resistant wood glue
4. ½-inch exterior plywood
Get a 2-by-2-foot piece.
5. 6d finish nails
6. Clear spar urethane
Contribute to This Story Below