Photo: Geoffrey Gross
«»
Tap 3-in. (10d) finishing nails partway into the crack, spaced 12 in. apart. You'll use them to align the injection ports with the crack.
Step 2: Block Out the Injection Ports
Introduction
Step 1
Repairing the Crack
Step 2
Block Out the Injection Ports
Step 3
Mix the Epoxy Sealer
Step 4
Attach the Injection Port
Step 5
Spread Sealer Along the Crack
Step 6
Inject the Epoxy into the Crack
Step 7
Seal Up the Injection Ports
Step 8
Cut Away the Injection Ports
Contribute to This Story Below