Step 10: Install the Field

man installing the rest of the tile sheets for a glass mosaic backsplash
Photo: Kolin Smith
«»
Continue to add tile sheets to the wall in the focal area, working from the bottom up. When that spot is complete, fill in the rest of the field, working from the centerline outward, then upward. Line up the joints between sheets closely, a bit tighter than the joints between individual tiles on one sheet but not so close that they touch one another. Doing this makes the joints between sheets "disappear" so that the tiles looks continuous on the wall.
Ask TOH users about Tile

Contribute to This Story Below

    More in Painting & Finishes

    Tools List

    • drill
      drill/driver
    • notched trowel
      trowel with 3/16-by-¼-inch V-notch
    • utility knife
      utility knife
    • hammer
      hammer
    • Glass Nippers
      two-wheeled glass nippers
    • rubber float
      epoxy grout float
    • drywall bucket
      5-gallon flat-bottomed mud bucket
    • bucket with sponge
      small bucket
    • grout sponge
      grout sponge
    • scrub brush
      nylon scrub brush
    • caulk gun
      caulk gun

    Shopping List

    Paper-faced translucent glass mosaic sheet tile. The facing is peeled off once the tiles are set on the wall

    Kraft paper to protect your counters

    Painter's tape

    Scrap 1x lumber for a temporary ledger

    1½-inch drywall screws

    80-grit sanding sponge for roughing painted drywallSealer-primer paint

    Thinset mortar. Choose a quality white latex-fortified portland cement thinset.

    Scrap cardboard to use as a spacer

    Grout Make sure it's a flexible grout approved by the tile maker. We chose a colorized, premixed urethane water-based grout that "gives" when the glass expands and requires no sealant

    Acrylic caulk that matches the grout