Step 7: Remove Excess Material From the Corner Pieces

man using a hammer to remove excess mortar from corner pieces used to create a stone veneer surround
Photo: Wendell T. Webber
«»
Hold a stone so that the waste side hangs over the edge of your work surface. Strike the waste side with a brick hammer to create a natural-looking split. Repeat for all corner pieces.

Tip: When removing excess material from a corner piece, line it up so that the score line is roughly even with the edge of your work surface, and hold it firmly against the surface to prevent the entire stone from breaking.
Next

Related Content

Ask TOH users about Fireplaces
Discuss

Contribute to This Story Below

Add Comment

    More in Interior

    Tools List

    Close
    • studfinder
      Stud finder
    • staple gun
      Staple gun
    • hammer
      Hammer
    • flat finishing trowel
      Finishing trowel
    • notched trowel
      Tiling trowel with 3/8-inch notch
    • angle grinder
      Grinder fitted with a diamond masonry blade
    • brick trowel
      Brick trowel
    • brick hammer
      Brick hammer
    • grout sponge
      Grout sponge or spray bottle
    • grout bag
      Grout bag
    • masonry striking tool
      Masonry striking tool
    • Whisk Broom
      Whisk broom

    Shopping List

    Close
    1. Stone veneer. Get about 20 percent more than you need to cover your fireplace, to accommodate fit and breakage.

    2. Builder's felt. It acts as a moisture barrier between the mortar and your walls to prevent water damage.

    3. Metal lath to install over the felt. It keeps the mortar in place, creating a base for the stone veneer.

    4. 3/8- or ½-inch staples.

    5. 15/8 -inch galvanized roofing nails.6. Veneer mortar. It contains special additives to create a strong bond between the stone veneer and the surface to which it's attached.

    7. Plastic sheeting. Tape it to your walls, floor, and hearth to protect them while you work.

    8. Painter's tape.

    9. Old drop cloth (optional).