Step 5: Drill Holes for the Leg Bolts

man using a drill driver to drill holes for the leg bolts
Photo: Wendell T. Webber
«»
Using a drill driver fitted with a 3/8-inch drill bit, bore a hole at the back end of each long side that's 1½ inch from the bottom edge and 3½ inches from the shortest point at the back of the box.
Next

Related Content

Ask TOH users about Pets
Discuss

Contribute to This Story Below

Add Comment

    More in Living Spaces

    Tools List

    Close
    • jigsaw
      Jigsaw
    • speed square
      Speed square
    • drill
      Drill/driver fitted with a 3/8-inch drill bit
    • Natural Bristle Brush
      Paint brush
    • putty knife
      Putty knife
    • flathead screwdriver
      Screwdriver
    • adjustable wrench
      Adjustable wrench

    Shopping List

    Close
    1. 1x12 laminated shelving board Get one 6-foot board.

    2. 1x5 Get two 8-foot boards.

    3. 1 5/8-inch trim head screws

    4. 3/8-inch 2½-inch bolts to attach the legs to the box. Get two.

    5. 3/8-inch washers Get ten.

    6. 3/8 inch locking nuts Get two.

    7. Wood glue

    8. Wood filler

    9. Piano hinge Get one that's 30 inches long. 10. Folding door hinge

    11. Toy box lid supports

    12. Drawer pull

    13. Nonskid rubber strips or pads

    14. Round skid feet

    15. Latex primer

    16. Latex semi-gloss paint

    17. Contact cement

    18. Non-skid/sisal rug

    19. Coffee can