Photo: Tria Giovan
«»
Using a hammer and nailset, make small dents in the metal at the folded-over edges of the wrapped top. Pin the metal to the plywood with nails 4d finishing nails.
Step 5: Tack the Metal to the Top
Introduction
Overview
Step 1
Cut the Top and Sides
Step 2
Cut the Metal Covers
Step 3
Wrap the Plywood in Metal
Step 4
Crease the Metal Covers
Step 5
Tack the Metal to the Top
Step 6
Finish the Doors
Step 7
Assemble the Base
Step 8
Mount the Doors
Step 9
Attach the Hardware
More in Kitchen
Tools List
-
Circular saw
-
Cordless drill with bit set
-
Tin snips
-
Pliers
-
Clamps
-
Hammer with nailset
Shopping List
1. two 14-inch-square wood planter boxes
2. two cabinet door catches
3. 4-by-4-foot sheet of ½-inch plywood
4. 2-by-4-foot sheet of 0.09-mil galvanized sheet metal
5. hooks6. two door pulls
7. four 4-inch strap hinges
8. four 3-inch casters with locks
9. 2½-inch deck screws
10. 1-inch deck screws
11. 4d galvanized nails
2. two cabinet door catches
3. 4-by-4-foot sheet of ½-inch plywood
4. 2-by-4-foot sheet of 0.09-mil galvanized sheet metal
5. hooks6. two door pulls
7. four 4-inch strap hinges
8. four 3-inch casters with locks
9. 2½-inch deck screws
10. 1-inch deck screws
11. 4d galvanized nails
Contribute to This Story Below