Step 1: Glue and Nail Rosettes

Glue and nail rosettes
Photo: David Carmack
«»
Using a circular saw, cut a piece of 1x3 to the length of the four rosettes lined up side by side. Apply wood glue between the rosettes and along the front edge of the 1x3. Glue and face-nail the rosettes to the edge of the board, driving a 4d finishing nail at the two bottom corners of each rosette.
Ask TOH users about Storage

Contribute to This Story Below

    Tools List

    • miter saw
      Miter Saw
    • hammer
      Hammer
    • drill
      Drill Driver
    • wood glue
      Wood Glue
    • wood putty
      Wood Putty
    • sand paper
      150-grit Sandpaper
    • paintbrush
      Polyester Nylon Paintbrush

    Shopping List

    1. 3-inch Rosettes

    2. 7-inch Shelf Brackets

    3. 1x3 Pine

    4. Small Crown Molding5. 1½-inch Multi-Purpose Screws

    6. 4 Penny Finish Nails

    7. Primer and Paint