Step 6: Attach Horizontal Frame Pieces

attach horizontal frame pieces
Photo: Kolin Smith
«»
Set the horizontal frame pieces into the notches on either upright. Holding a Speed square at the corners where the frame meets, screw the 2x4s together using 3-inch screws. Screw straight into the top corners, but wherever the upright has back-to-back notches, angle the screws so that they don't interfere with the other side.
Next

Related Content

Ask TOH users about Gardening
Discuss

Contribute to This Story Below

Add Comment

    More in Yard & Garden

    Tools List

    Close
    • circular saw
      circular saw
    • speed square
      Speed square
    • straightedge guide
      straightedge
    • combination square
      combination square
    • chisel
      chisel
    • hand saw
      handsaw
    • drill
      drill/driver
    • two-foot level
      2-foot level
    • post hole digger
      posthole digger
    • 7 foot digging bar
      digging bar
    • pointed shovel
      shovel
    • tamper
      small hand tamper

    Shopping List

    Close
    1. Cedar or pressure-treated 2x4s for the frame. Keep in mind that two adjoining trellis panels will share one vertical frame piece.

    2. Cedar or pressure-treated 1x1s for the stops that hold the lattice.3. Cedar or pressure-treated lattice fencing comes in 4-by-8-foot sheets. If you're building more than one panel, get both straight and diagonal lattice. 4. Cedar or pressure-treated 2x6—to cap the tops of the panels.

    5. ¾-inch gravel for drainage in the postholes. Four 50-pound bags will be enough.

    6. 1 5/8-inch self-tapping deck screws

    7. 3-inch self-tapping deck screws