Step 5: Match the Profiles First

push the two mitered ends together to create the inside corners
Photo: Kolin Smith
«»
Push the two mitered ends together to create the inside corners, making sure their faces align in the corner. Match up the detail of the profile first, then use mud to fill any small gaps between the molding and the ceiling on either side.
Next

Related Content

Ask TOH users about Crown Molding
Discuss

Contribute to This Story Below

Add Comment

    More in Molding & Carpentry

    Tools List

    Close
    • miterbox with saw
      Miter box with hand saw
    • putty knife
      6-inch and 1½-inch putty knives
    • rasp
      rasp or sanding block
    • hammer
      hammer
    • grout sponge
      sponge
    • angled sash paintbrush

    Shopping List

    Close
    1. Plaster-coated Foam Molding
    Get 10 percent more than you think you'll need, to accommodate offcut.

    2. Joint Compound
    Lightweight, easy-sanding premixed compound is best. A 1-gallon container will cover about 60 feet of molding.

    3. 8d Finishing Nails
    To support long runs of larger molding profiles as the compound dries. 4. 150-grit Sandpaper

    5. Painter's Tape

    6. Primer and Paint