Step 11: Install the frames

Using a caulk gun, apply panel adhesive to the four sides of the frame
Photo: Kolin Smith
«»
As you put the frames on the wall, it's more important to align them relatively parallel to the elements around them—the chair rail, a wall corner, or door trim—than to check them for level or plumb. The frames go up with panel adhesive, which will hold them to the wall permanently, but quick-drying hot glue clamps them in place while the adhesive sets.

Using a caulk gun, apply panel adhesive to the four sides of the frame. Using a hot-glue gun, put a dab of glue on each corner.
Ask TOH users about Wainscoting

Contribute to This Story Below

    More in Molding & Carpentry

    Tools List

    • random orbit sander
      random-orbit sander fitted with 150-grit paper
    • combination square
      combination square
    • framing square
      framing square
    • pneumatic brad nailer
      pneumatic brad nailer (rents for $55 per day with compressor)
    • miter saw
      miter saw
    • hand clamps
      spring clamps
    • caulk gun
      caulk gun
    • hot glue gun
      hot-glue gun
    • putty knife
      small putty knife
    • paintbrush
      paint brush
    • paintroller
      paint roller

    Shopping List

    Molding Typically, base cap or panel molding works best for creating frames. Make sure to get 10 to 20 percent more than you think you'll need, to accommodate offcut waste.

    Scrap Plywood and Wood Blocks to make a jig for building the frames

    2-Inch Brad Nails

    Wood Glue220-Grit Sandpaper for smoothing mitered corners and filled nail holes

    Panel Adhesive to secure the frames to the wall

    Hot-Glue Cartridge

    Wood Putty

    Paintable Caulk

    Primer and Paint