Step 9: Cut the molding

cut the molding
Photo: Kolin Smith
«»
Continue cutting all the molding for this length with the stop in place. Adjust the stop for each of the different lengths on your cut list, and cut until you have the pieces you need to build all the frames.
Next

Related Content

Ask TOH users about Wainscoting
Discuss

Contribute to This Story Below

Add Comment

    More in Molding & Carpentry

    Tools List

    Close
    • random orbit sander
      random-orbit sander fitted with 150-grit paper
    • combination square
      combination square
    • framing square
      framing square
    • pneumatic brad nailer
      pneumatic brad nailer (rents for $55 per day with compressor)
    • miter saw
      miter saw
    • hand clamps
      spring clamps
    • caulk gun
      caulk gun
    • hot glue gun
      hot-glue gun
    • putty knife
      small putty knife
    • paintbrush
      paint brush
    • paintroller
      paint roller

    Shopping List

    Close
    Molding Typically, base cap or panel molding works best for creating frames. Make sure to get 10 to 20 percent more than you think you'll need, to accommodate offcut waste.

    Scrap Plywood and Wood Blocks to make a jig for building the frames

    2-Inch Brad Nails

    Wood Glue220-Grit Sandpaper for smoothing mitered corners and filled nail holes

    Panel Adhesive to secure the frames to the wall

    Hot-Glue Cartridge

    Wood Putty

    Paintable Caulk

    Primer and Paint