Photo: Wendell T. Webber
«»
Using a pair of scissors, cut the ends off a 1-liter soda bottle to make
a cylinder.
Step 6: Make the seed holder
Introduction
Overview
Step 1
Lay out and cut the parts
Step 2
Make the top
Step 3
Build the base
Step 4
Wire the base
Step 5
Make a hole for the wire in the top
Step 6
Make the seed holder
Step 7
Assemble the feeder
Step 8
Fill the feeder with seed
Step 9
Make a hook for the feeder
Step 10
Hang the feeder
More in Landscaping
Tools List
-
Tape measure
-
Combination square or framing square
-
Compass
-
Safety glasses
-
Bar clamps
-
Jigsaw
-
Random-orbit sander or sanding block with 120-grit sandpaper
-
Hammer
-
Drill/driver fitted with ¼-inch bit and ½-inch spade bit
-
Scissors
-
Wire cutters
-
Screwdriver
Shopping List
1. 2 feet of 1x6 cedar
2. 2 feet of ¼-inch dowel
3. 120-grit sandpaper
4. Wood glue
5. 4d finish nails
6. ⅜-inch rubber grommet
7. Epoxy8. Copper-topped post cap for a 4x4
9. 1-liter soda bottle
10. Three feet of 5⁄32-inch vinyl-covered wire
11. ⅝-inch blued tacks
12. Eye screw
2. 2 feet of ¼-inch dowel
3. 120-grit sandpaper
4. Wood glue
5. 4d finish nails
6. ⅜-inch rubber grommet
7. Epoxy8. Copper-topped post cap for a 4x4
9. 1-liter soda bottle
10. Three feet of 5⁄32-inch vinyl-covered wire
11. ⅝-inch blued tacks
12. Eye screw
Contribute to This Story Below