Step 6: Attach the butcher block

attach the butcher block using screws and kitchen and bath sealant
Photo: Kolin Smith
«»
Using a drill/driver fitted with a ½-inch paddle bit, drill through the center of the blocking or through the solid cabinet top at one furring strip. Create one hole like this on each cabinet.

TOH Tip: When making the holes in the cabinets, keep the bit from blowing out the wood around the hole by clamping a scrap block of wood against the cabinet top.
Ask TOH users about Kitchen Countertops

Contribute to This Story Below

    Tools List

    • combination square
      Combination square
    • utility knife
      Utility knife
    • pencil compass
      Compass or scribe
    • hot glue gun
      Hot glue gun
    • hand saw
      Handsaw
    • drill
      Drill/driver fitted with 1/8-inch drill bit and ½-inch paddle bit Caulk gun

    Shopping List

    1. Butcher Block Must be ordered in advance; plan six weeks for delivery

    2. Cardboard to make a template for ordering the butcher block. An old packing box will do, as will poster board—as long as it's stiff enough to hold up to scribing but flexible enough to be folded for mailing.

    3. Painter's tape

    4. Scrap wood to use

    as blocking on open-topped cabinets or as furring strips on solid-topped cabinets. Blocking should be 3/4-inch plywood or 1x material, but ¼-inch plywood will suffice for furring strips. 5. Kitchen and Bath Sealant for gluing the butcher block to the cabinets. Look for a 100 percent silicone product

    6. 1-Inch Fender Washers

    7. 1½-Inch Deck Screws to attach the blocking and the butcher block to the cabinets

    8. Mineral Oil or any other FDA-approved oil for food-prep surfaces. Walnut oil is a good organic alternative to petroleum-based mineral oil because it won't go rancid like other food-based oils.