Step 1: Install the toekick

Installing the toekick of a custom entertainment center with drill
Photo: Donna Moser/Alderman Studio
«»
Remove the baseboard molding from the wall where the entertainment center will go. Then install a 3½-inch-high platform (also called a toekick) for the cabinets to sit on. Build the platform out of 2x4s; fasten the parts together with 3-inch drywall screws.
Ask TOH users about Media Rooms

Contribute to This Story Below

    Tools List

    • drill
      Drill/driver
    • circular saw
      Circular saw or hand saw
    • hammer
      Hammer or pneumatic finish nailer
    • 16-foot tape measure
      Tape measure
    • two-foot level
      Level
    • adjustable clamp
      Clamps, for holding together cabinets
    • flat prybar
      Thin pry bar, used to remove existing molding from walls
    • studfinder
      Stud finder, for locating wall studs
    • Countersink bit
      Countersink drill bit, used to bore screw-pilot and countersink holes in face frames

    Shopping List

    1. Stock cabinets with matching trim and plywood skins

    2. Contact cement, used to adhere prefinished plywood skin to assembled cabinets

    3. Paintbrush and paint roller, used to apply contact cement

    4. 1 ½-inch finishing nails, for attaching trim to cabinets

    5. 2 x 4s, used to build platform

    6. 2 ½- and 3-inch drywall screws, for joining together cabinets and assembling platform

    7. Wood shims, used to level platform and plumb cabinets

    8. 3/4 x 1-inch wood strips, to provide nailing support for crown molding