Step 7: Back-Butter the Stone

back-butter the stone
Photo: Wendell T. Webber
«»
Separate the stones into piles of corner, short, long, and rectangular pieces to organize them and to help create a random color pattern.

Start with a corner piece. Using a pointing trowel, butter the back of one of the L-shaped stones with a 1-inch layer of mortar. Scrape excess mortar from the edges of the stone, then use the trowel point to create V-shaped air pockets in the wet mortar.
Next

Related Content

Ask TOH users about Outdoor Kitchens
Discuss

Contribute to This Story Below

Add Comment

    More in Kitchen

    Tools List

    Close
    • circular saw
      Circular Saw for cutting the framing lumber and plywood

    • drill
      Drill Driver

    • metal cutting snips
      Tin Snips for cutting the wire lath

    • hammer
      Hammer

    • staple gun
      Staple Gun

    • masonry hoe
      Mixing Trough and Masonry Hoe

    • flat finishing trowel
      Hawk and Finishing Trowel

    • notched trowel
      1/2-Inch Notched Trowel

    • mason's trowel
      Pointing Trowel

    • miter saw
      Miter Saw fitted with diamond blade

    • angle grinder
      Grinder fitted with diamond blade

    Shopping List

    Close
    1. Cultured stone to veneer the kitchen box. Available at home centers and stone yards. You will need a few boxes of corner pieces, as well as flat face pieces, sold by the square foot. Get about 10 percent more than you need to account for trims, cuts, and broken pieces.

    2. Pressure-treated 2x4s to build the frame for the box. You will need 15 to 20 10-foot pieces.

    3. 3/4-inch pressure-treated plywood to sheathe the frame. Get four 8-by-4-foot sheets.

    4. 2½-inch ceramic-coated deck screws to hold the frame together.

    5. 2-inch ceramic coated deck screws to attach the plywood to the frame.

    1¼-inch ceramic coated deck screws to build plywood boxes for the cabinets.

    6. Construction adhesive.7. Metal post standoffs to act as feet and raise the frame off the ground, preventing moisture from wicking up into the wood. You will need a total of 12.

    8. 15-pound builder's felt to provide a moisture barrier between the mortar and the wood.

    9. ½-inch staples

    10. Wire lath to create a base on which the mortar hangs.

    11. Stainless-steel roofing nails to attach the lath to the plywood.

    12. Type S mortar (or one labeled "for veneer stone") to affix the stone to the box. Get four or five 80-pound bags.

    13. Stainless-steel doors (optional) to finish cabinets. Make sure they come on a face frame.