Step 8: Secure and Conceal the Hose

secure and hide the pump hose
Photo: Kolin Smith
«»
Where the hose exits the water, wedge it between two rocks without crushing it. Conceal it with a third rock. Arrange and secure the hose through the rocks and over a stack to position the waterfall.

Once the pump and hose are secure, plug the cord into an exterior GFCI outlet. Watch the water flow and make sure it looks natural leaving the hose but still spills back into the pond.
Next

Related Content

Ask TOH users about Outdoor Structures
Discuss

Contribute to This Story Below

Add Comment

    More in Landscaping

    Tools List

    Close
    • pointed shovel
      Shovel
    • four-foot level
      Level
    • 30-foot tape measure
      Tape Measure
    • utility knife
      Utility Knife
    • garden hose
      Garden Hose

    Shopping List

    Close
    1. Pond Liner, which is available off the roll at garden centers or precut in kits. Buy one 4 feet longer and wider than your pond dimensions to fit 18 inches deep.

    2. General Purpose Sand to cover and smooth over stones or roots. Three or four bags should be enough.

    3. Newspaper or Burlap to cover the sand.

    4. Scrap 2x4 to help level the pond.

    5. Pea Gravel to create drainage for overflow.

    6. Large Rocks to create the border and waterfall. Gather them from around the pond or buy them at a stone yard. 7. Submersible Recirculating Pump to keep water aerated and to create a waterfall. Get one that pumps 200 or fewer gallons per minute for a gentle flow.

    8. Air Line Tubing to carry the water to the waterfall. Available at hardware stores or pet stores that sell fish tanks.

    9. 2-inch PVC conduit to protect the buried pump