Step 6: Install the Pump

install the water pump
Photo: Kolin Smith
«»
Thread the pump's cord through a section of PVC conduit cut to length. Place the PVC conduit in the trench and backfill the soil.

Hold one end of the recirculating hose as you set the pump in the deepest part of the hole.
Ask TOH users about Outdoor Structures

Contribute to This Story Below

    More in Landscaping

    Tools List

    • pointed shovel
      Shovel
    • four-foot level
      Level
    • 30-foot tape measure
      Tape Measure
    • utility knife
      Utility Knife
    • garden hose
      Garden Hose

    Shopping List

    1. Pond Liner, which is available off the roll at garden centers or precut in kits. Buy one 4 feet longer and wider than your pond dimensions to fit 18 inches deep.

    2. General Purpose Sand to cover and smooth over stones or roots. Three or four bags should be enough.

    3. Newspaper or Burlap to cover the sand.

    4. Scrap 2x4 to help level the pond.

    5. Pea Gravel to create drainage for overflow.

    6. Large Rocks to create the border and waterfall. Gather them from around the pond or buy them at a stone yard. 7. Submersible Recirculating Pump to keep water aerated and to create a waterfall. Get one that pumps 200 or fewer gallons per minute for a gentle flow.

    8. Air Line Tubing to carry the water to the waterfall. Available at hardware stores or pet stores that sell fish tanks.

    9. 2-inch PVC conduit to protect the buried pump