Step 7: Fill in the field

filling in the field to build a brick path
Photo: Kolin Smith
«»
Widen the notches on either side of the screed so it fits between the edge bricks with about ¼ inch of wiggle room on either side. Use it to screed the sand again. Begin laying the pattern between the edging: Hold a brick above the sand, press it against the edge brick, and position it so it’s even with the start of the path. Once it’s in position, set it down directly in place. Using a mallet, tap the brick level with the edge course. Continue laying bricks in this manner, hitting each to set it (as shown), until the path is filled in. Check the slope of the bricks with the level and scrap-wood attachment as you work. When you lay the bricks, make sure not to drag them across the sand or your joints will fill with sand and they won’t be tight.
Ask TOH users about Driveway & Walkway

Contribute to This Story Below

    Tools List

    • square spade
      Spade
    • hand saw
      Handsaw
    • four-foot level
      4-foot level
    • tamper
      Hand tamper
    • drill
      Drill/driver
    • mallet
      Deadblow mallet
    • push broom
      Push broom

    Shopping List

    1. BRICKS
    Choose bricks rated for severe weather (SW), also called "clay pavers" at the stone yard. Modular bricks measure 8 inches long, 4 inches wide, and 1½ inches thick, but actual dimensions can vary by as much as half an inch. Measure the bricks you like and figure out how many you'll need for your pattern. Depending on the pattern's waste, figure about five bricks per square foot

    2. GRADED BASE
    (a combination of crushed stone and stone dust), for creating a sturdy, porous base

    3. MASONRY SAND
    or stone dust, for creating a smooth, porous base between the graded base and the bricks

    4. 1x4 COMPOSITE LUMBER
    to use as temporary guides along the edges of the path as you set the bricks. Composite lumber is easier to bend for curves than standard lumber, though the latter will also work

    5. WOODEN STAKES
    at least 1½ feet long, to secure the guide rails in place

    6. 1 1/4-inch DECK SCREWS
    to temporarily attach the stakes to the guide rails

    7. 2x4 LUMBER
    to make a screed for shaping the sand

    8. GARDEN EDGING
    (optional) to hold together certain patterns of brick. Must go at least 6 inches into the ground