Step 8: Attach the eyebolt

installing the eye bolt to attach the tree swing rope
Photo: Wendell T. Webber
«»
Thread an eyebolt through the hole so that the eye faces down. Slip on a washer, then two nuts, one after the other. Use a wrench to tighten the two nuts as you hold the loop of the bolt steady with a screwdriver.
Ask TOH users about Outdoor Structures

Contribute to This Story Below

    More in Landscaping

    Tools List

    • 16-foot tape measure
      Tape Measure
    • combination square
      Combination square
    • bar clamps
      Bar clamps
    • jigsaw
      Jigsaw
    • drill
      Drill/driver fitted with 3/16-inch drill bit, 1-inch spade bit, and long -inch spade bit
    • pencil compass
      Compass
    • random orbit sander
      Random-orbit sander
    • paintbrush
      2-inch paintbrush
    • artist paintbrush
      Small artist's paintbrush
    • Phillips screwdriver
      Screwdriver
    • adjustable wrench
      Wrench

    Shopping List

    1. 1x8 oak, maple, or other hardwood board, 4 feet long

    2. ¾-inch polypropylene rope

    3. 120-grit sandpaper

    4. Exterior-grade wood glue

    5. 1¼-inch deck screws6. Exterior latex paint

    7. Carabiner or spring clip

    8. -inch-thick, 10-inch-long stainless-steel or galvanized eyebolt with washer and two nuts

    9. ¾-inch rope thimble