Photo: Geoffrey Gross
«»
Mark the outline of the chest onto the wall using a level, then cut out the wallboard using a drywall saw.
Step 6: Outline the chest
Introduction
Step 1
Trim overhanging ends
Step 2
Trim feet
Step 3
Trim dresser to fit opening
Step 4
Close the gap
Step 5
Paint, stain or varnish unfinished wood (if needed)
Step 6
Outline the chest
Step 7
Remove interferences
Step 8
Install supports
Step 9
Insert dresser
Step 10
Secure the chest
Step 11
Finish up
More in Living Spaces
Tools List
-
Drill/driver
-
Hammer
-
Handsaw
-
Tape measure
-
Level
-
Drywall saw
-
Circular saw
Shopping List
1) Chest of drawers
2) 2- and 3-inch drywall screws
3) Paint, stain or varnish
used to seal bare wood
4) Paintbrush
5) Drop cloth
6) 1/8-inch hardboard
used to cover opening cut into rear of chest
7) 3/4-inch wire nails
used to secure hardboard
8) Doorstop molding
used to trim around installed chest
9) 1 1/2-inch finishing nails
for attaching doorstop molding
2) 2- and 3-inch drywall screws
3) Paint, stain or varnish
used to seal bare wood
4) Paintbrush
5) Drop cloth
6) 1/8-inch hardboard
used to cover opening cut into rear of chest
7) 3/4-inch wire nails
used to secure hardboard
8) Doorstop molding
used to trim around installed chest
9) 1 1/2-inch finishing nails
for attaching doorstop molding
Contribute to This Story Below