Step 2: Treat and lift the posts

step 2: treat and lift the post to create an arbor «»
Treat the end of the post with wood preservative. Then lift up the post and have a helper align the center hole with the pipe. Slowly lower the post over the pipe until it sits on the concrete footing. Do the same for the remaining five posts. Check to be sure that each post is perfectly plumb; if necessary, drive a cedar-shingle shim underneath to align it.
Next

Related Content

Ask TOH users about Outdoor Structures
Discuss

Contribute to This Story Below

Add Comment

    More in Landscaping

    Tools List

    Close
    • bit auger
      Auger bit
    • drill
      Drill
    • 30-foot tape measure
      Tape measure
    • finish hammer
      Hammer
    • router
      Router

    Shopping List

    Close
    1. 8x8 POSTS

    6 required



    2. 2x8 CROSS BEAMS

    6 required



    3. 2x6 RAFTERS

    7 required



    4. 1x2 LATTICE STRIPS

    9 required



    5. 1x3 TRIM

    applied around tops of each post



    6. 3/4-INCH-DIAMETER X 42-INCH-LONG GALVANIZED-METAL PIPE

    used to hold posts in place



    7. PRIMER AND PAINT OR STAIN

    8. 2- AND 3-INCH DECKING SCREWS

    9. CONCRETE MIX

    for creating poured-concrete footings



    10. 2 1/2-INCH GALVANIZED FINISHING NAILS

    used to attach 1x3 trim to posts



    11. WOOD PRESERVATIVE

    used to treat the ends of the posts



    12. 1/2-INCH PRESSURE-TREATED PLYWOOD

    cut into 7 [FRACTION 1/2]-inch-square fastening plates