«»
For larger areas, such as patios or driveways, spread the dressing with a long-handle squeegee. Press down hard to fill all surface imperfections. Follow up with the push broom.
Step 6: Spreading on large areas
Introduction
Step 1
Fill the cracks
Step 2
Mask expansions
Step 3
Mix concrete
Step 4
Spread the dressing
Step 5
Texture the surface
Step 6
Spreading on large areas
Step 7
Finish up
«»
More in Exterior
Tools List
-
Electric drill with mixing paddle
-
Caulking gun
-
Putty knife
-
Trowel
-
Push broom
-
Pump sprayer
Shopping List
1. CONCRETE RESURFACER
one 20-pound bag will cover about 50 to 60 square feet
2. 5-GALLON BUCKET
for mixing concrete resurfacer
3. TSP (trisodium phosphate)
used to clean concrete prior to resurfacing
4. DUCT TAPE
used to cover expansion joints prior to resurfacing
5. CONCRETE-REPAIR CAULK
used to fill cracks up to ½-inch wide
6. MASONRY MORTAR MIX
for patching cracks wider than ½-inch
7. MASONRY SEALER
for treating the concrete after resurfacing
one 20-pound bag will cover about 50 to 60 square feet
2. 5-GALLON BUCKET
for mixing concrete resurfacer
3. TSP (trisodium phosphate)
used to clean concrete prior to resurfacing
4. DUCT TAPE
used to cover expansion joints prior to resurfacing
5. CONCRETE-REPAIR CAULK
used to fill cracks up to ½-inch wide
6. MASONRY MORTAR MIX
for patching cracks wider than ½-inch
7. MASONRY SEALER
for treating the concrete after resurfacing
Contribute to This Story Below