«»
Remove the 2x4 braces at the corners. Lay the next course of timbers on top of the base course, but arrange them so they overlap at the corners in the opposite direction from the first course. This will create a lapped pattern.
Step 5: Position the second course
Introduction
Overview
Step 1
Cut the timbers
Step 2
Lay out the sandbox perimeter
Step 3
Dig out the center of the box
Step 4
Lay the base course
Step 5
Position the second course
Step 6
Tie the courses together
Step 7
Line the box with landscape fabric
Step 8
Lay the third timber course
Step 9
Fill the box with sand
«»
More in Landscaping
Tools List
-
Spade and Shovel
-
Circular saw
-
Speed square
-
Framing square
-
4-foot level
-
Rubber mallet or sledge
-
Hammer
-
Heavy duty drill/driver or impact driver fitted with 1/4-inch nut driver bit
Shopping List
1. 4x4 CEDAR TIMBERS
to make up the sides of the sandbox
2. SCRAP 2x4
to hold the timbers square while you fasten them down
3. 3-INCH DECKING SCREWS
4. 6-INCH SELF-TAPPING TIMBER SCREWS
5. LANDSCAPE FABRIC
to line the box and keep weeds from growing up through the sand
6. PLAY SAND
aka natural sand
7. TARP
large enough to cover the completed sandbox
8. VELCRO TAPE
to hold the tarp down
to make up the sides of the sandbox
2. SCRAP 2x4
to hold the timbers square while you fasten them down
3. 3-INCH DECKING SCREWS
4. 6-INCH SELF-TAPPING TIMBER SCREWS
5. LANDSCAPE FABRIC
to line the box and keep weeds from growing up through the sand
6. PLAY SAND
aka natural sand
7. TARP
large enough to cover the completed sandbox
8. VELCRO TAPE
to hold the tarp down
Contribute to This Story Below