Step 9: Finishing touches

building a toolbox
Photo: Wendell T. Webber
«»
Cut a few lengths of hockey-stick tape, and use them to wrap the handle to make a comfortable grip.

If you want, nail furniture glides onto the box’s bottom to keep it from scratching floors. Then fill it with tools, grab it by the handle, and you’re ready to go!
Ask TOH users about Workshop Accessories

Contribute to This Story Below

    Tools List

    • 16-foot tape measure
      Tape measure
    • hammer with nailset
      Hammer and nailset
    • combination square
      Combination square
    • hand clamps
      Spring clamps
    • jigsaw
      Jigsaw, circular saw, or handsaw
    • drill
      Drill/driver with -inch drill bit and ½- and 1-inch spade bits
    • safety glasses
      Safety glasses
    • random orbit sander
      Random-orbit sander or sanding block
    • bar clamps
      Bar clamps
    • putty knife
      Putty knife
    • paintbrush
      Paintbrush
    • straightedge guide
      Straightedge saw guide

    Shopping List

    1. 2x4 foot piece of ½-inch birch veneer plywood

    2. Plastic jars
    (optional: for keeping nails and screws organized in the toolbox)

    3. 120-grit sandpaper

    4. Stainable wood glue

    5. Clean Rag6. 4d finish nails

    7. Stainable wood putty

    8. Water-based stain

    9. Latex gloves

    10. Hockey-stick tape

    11. Nail-on furniture glides
    (optional)