Photo: Wendell T. Webber
«»
Using a jigsaw, and with the bracket clamped to the worktable, cut along the slot lines to meet the ¼-inch hole. Repeat this process with the other bracket.
Step 4: Cut the slots
Introduction
Overview
Step 1
Lay out the pieces
Step 2
Cut the wood
Step 3
Mark and drill the brackets
Step 4
Cut the slots
Step 5
Drill the dowel holes
Step 6
Attach the hinges
Step 7
Attach the cross braces and brackets
Step 8
Mount the boards
Step 9
Put on the plastic trays
Step 10
Add the paper
More in Interior
Tools List
-
Tape measure
-
Combination square
-
Bar clamps
-
Spring clamps
-
Jigsaw
-
Drill/driver fitted with 3/32-inch and ¼-inch, and ⅛-inch drill bits and a 1¼-inch hole saw
-
Safety glasses
Shopping List
1. Three 8-foot oak or maple 1x3s
2. Two 23x23-inch magnetic dry-erase boards
3. 1-inch dowel, 3 feet long
4. Two 4-inch strap hinges
5. ¾-inch #10 wood screws and eight washers6. 1¼-inch #8 wood screws and two washers
7. Two plastic trays or kitchen drawer organizers
8. One 2-foot-wide roll of paper
2. Two 23x23-inch magnetic dry-erase boards
3. 1-inch dowel, 3 feet long
4. Two 4-inch strap hinges
5. ¾-inch #10 wood screws and eight washers6. 1¼-inch #8 wood screws and two washers
7. Two plastic trays or kitchen drawer organizers
8. One 2-foot-wide roll of paper
Contribute to This Story Below