Step 10: Put on the bat cutout

Put on the bat cutout
Photo: Wendell T. Webber
«»
Caulk the exposed sections of the 1x2s, then place the cutout onto them, just below the large front piece. Leave a ½-inch gap between the two for the air vent. Clamp the piece, and attach it in place with a single 1-inch screw on each side.
Next

Related Content

Ask TOH users about Yard & Garden
Discuss

Contribute to This Story Below

Add Comment

    More in Yard & Garden

    Tools List

    Close
    • 30-foot tape measure
      Measuring tape
    • straight edge
      Straightedge
    • combination square
      Combination square
    • hand clamps
      Spring clamps
    • safety glasses
      Safety glasses
    • jigsaw
      Jigsaw
    • French curve and circle templates
    • drill
      Drill/driver fitted with ¼-inch drill bit
    • caulk gun
      Caulking gun
    • paintbrush
      Paintbrush (2-inch)
    • paintroller
      Foam roller (4-inch)
    • scissors
      Scissors
    • staple gun
      Staple gun

    Shopping List

    Close
    1. 2-by-4-foot section of ½-inch exterior-grade plywood

    2. One 6-foot 1x2

    3. ½-inch deer netting

    4. Exterior latex paint (black and another dark color)5. Low-VOC adhesive caulk

    6. 1-inch deck screws

    7. ⅜-inch staples

    8. 3½-inch deck screws