«»
Then slip a band clamp onto the overhead duct, insert the male end of the 90-degree elbow into the duct and tighten the clamp.
Step 5: Attach a 90-degree elbow
Introduction
Overview
Step 1
Pull the dryer away from the wall
Step 2
Tighten the clamp
Step 3
Attach the periscope
Step 4
Join the box vent to the overhead duct
Step 5
Attach a 90-degree elbow
Step 6
Finish
«»
More in Workspaces
Tools List
-
Screwdriver
-
Dryer Vent Brush
Shopping List
1. ADJUSTABLE PERISCOPE BOX VENT
2. A VENT KIT
Including two 4-inch diameter * 4-foot-long round aluminum flex vent, two elbows, and two band clamps(whirlpool)
2. A VENT KIT
Including two 4-inch diameter * 4-foot-long round aluminum flex vent, two elbows, and two band clamps(whirlpool)
Contribute to This Story Below