«»
Grab hold of the upper section of the periscope and lift up until it's a couple of inches above the back of the dryer. Plug in the power cord (turn the gas back on if necessary) and carefully push the dryer back against the wall.
Step 3: Attach the periscope
Introduction
Overview
Step 1
Pull the dryer away from the wall
Step 2
Tighten the clamp
Step 3
Attach the periscope
Step 4
Join the box vent to the overhead duct
Step 5
Attach a 90-degree elbow
Step 6
Finish
«»
More in Workspaces
Tools List
-
Screwdriver
-
Dryer Vent Brush
Shopping List
1. ADJUSTABLE PERISCOPE BOX VENT
2. A VENT KIT
Including two 4-inch diameter * 4-foot-long round aluminum flex vent, two elbows, and two band clamps(whirlpool)
2. A VENT KIT
Including two 4-inch diameter * 4-foot-long round aluminum flex vent, two elbows, and two band clamps(whirlpool)
Contribute to This Story Below