Step 3: Cover The Exposed Lath

Cover the exposed lath
Photo: Reena Bammi
«»
Using a utility knife, trim a piece of grade-D builder's paper to fit tightly along the boundary where the old stucco meets the exposed wood lath. Fasten the paper to the lath with roofing nails, then put a second layer of paper on top of the first.
Ask TOH users about Siding

Contribute to This Story Below

    Tools List

    • drywall knife
      4-inch drywall knife,
      used to scrape off loose stucco
    • wire brush
      Wire brush,
      for cleaning scraped wall surfaces
    • flat blade shovel
      Shovel,
      used to mix stucco
    • wheelbarrow
      Mortar trough or wheelbarrow,
      for mixing stucco
    • plaster hawk
      Hawk,
      used to hold stucco while working
    • mason's trowel
      Trowel,
      for applying stucco to wall
    • rubber float
      Rubber float,
      used to smooth stucco patch

    Shopping List

    1. Portland cement
    one 94-lb. bag

    2. Brick or Mason’s sand

    3. Hydrated lime

    4. Acrylic bonding agent

    5. Builder’s paper
    Grade D

    6. Plastic sheeting

    7. Expanded metal lath
    (aka diamond mesh)

    8. Duct tape