Step 2: Fit the trim to the screen openings

fitting the trim to the screen openings
Photo: Kolin Smith
«»
Using a miter box and handsaw, cut a 45-degree inside miter on a length of cove molding. Fit the cut end of the molding into one corner of a screen opening and hold it tight against the opening's edge. Mark the molding where it reaches the next corner. Cut another 45-degree miter at this mark, facing the other direction. Continue cutting molding in this manner until you have four pieces to fit the inner edge of the opening.
Next
Ask TOH users about Heating
Discuss

Contribute to This Story Below

Add Comment

    More in Plumbing, HVAC & Electrical

    Tools List

    Close
    • drill
      Drill/driver,
      with ½-inch spade bit and countersink bit
    • circular saw
      Circular saw
    • hand clamps
      Clamps
    • jigsaw
      Jigsaw
    • miterbox with saw
      Miter box and handsaw
    • metal cutting snips
      Tin snips
    • staple gun
      Staple gun
    • scribe
      Scribe,
      to contour box around baseboards

    Shopping List

    Close
    1. 3/4-INCH MDF

    Measure the front, sides and top of your radiator to determine how much you need.



    2. SCREEN

    Comes in 3-by-3 foot sheets. Get enough to cover the front opening and two side openings.



    3. SHEET METAL

    Slides behind the radiator to reflect heat outward.



    4. 3/4-INCH MOLDING

    to give a finished appearance to the screen openings.



    5. 1 5/8-INCH COARSE DRYWALL SCREWS

    to fasten the cover's sides and front.



    6. 1/2-INCH STAPLES

    to attach the screen to the cover.



    7. WOOD GLUE

    to attach molding.



    8. 4d FINISH NAILS

    for fastening the molding.



    9. 1x SCRAP

    to make cleats that hold the cover's top in place.



    10. FEET

    Check woodworking catalogs for furniture feet in metal or wood. You may need longer screws than the ones provided with the feet in order to fasten them through the thick MDF.