Step 3: Install ground stakes

Installing the ground stakes
Photo: Shelly Strazis
«»
Once you've got the tubing in position, use plastic ground stakes to hold it down. Be sure the hook at the top of the stakes fits over the tubing.

Wherever the tubing has to turn at a sharp angle or branch out to another section, cut it and reattach it with tee or elbow connectors. Cut the end of the tubing when you are finished; leave it open so you can flush it with water later.
Next

Related Content

Ask TOH users about Lawn Care
Discuss

Contribute to This Story Below

Add Comment

    More in Yard & Garden

    Tools List

    Close
    • tubing cutter
      Tubing Cutter,
      bypass pruner or scissors would suffice, but the thick tubing can dull the blades, making them less effective in the garden
    • 11-inch steel punch
      Hole Punch,
      comes with tubing

    Shopping List

    Close
    1. 1/2-INCH DRIP TUBING

    comes in 50-, 75- 100-, or 500-foot rolls, either with or without factory-installed emitters. Calculate the square footage of the area you want to irrigate, then figure on one foot of tubing per square foot of plant bed.




    2. 1/4-INCH DRIP TUBING

    use this smaller tubing to branch off from the main line and reach specific bushes, trees, or containers.



    3. TUBING CONNECTORS

    elbow, tee, and straight connectors allow you to turn the tubing without kinking it, or add on more lengths of tubing.



    4. WATER SOURCE CONNECTION KIT

    for attaching the tubing to an outdoor faucet. Kit should include a vacuum breaker, pressure regulator, a filter, and a connector for attaching the tubing.

    5. SPRAY AND DRIP ACCESSORIES

    including micro sprayers, small emitters, and foggers for reaching different plants around the garden.



    6. BARK MULCH