Step 4: Level the bookcase

LEVEL THE BOOKCASE
Photo: Kolin Smith
«»
Slide all the shelves into the frame. If some need coaxing, use a rubber mallet to gently tap them into place.

Check the bookcase for level. Place a level on each of the shelves. If one side needs to be raised up, tap thin wood shims under the foot.
Next

Related Content

Ask TOH users about Cabinets & Shelving
Discuss

Contribute to This Story Below

Add Comment

    More in Interior

    Tools List

    Close
    • circular saw
      Circular Saw
    • speed square
      Speed square,
      to guide circular saw as you cut support pieces
    • scribe
      Scribe,
      for transferring irregularities of the wall onto the trim so you can cut it to fit snugly
    • mallet
      Mallet,
      to coax tight-fitting shelves into slots
    • studfinder
      Stud sensor,
      to find where to attach bookcase to wall
    • jigsaw
      Jigsaw,
      to cut scribed trim pieces
    • 16-foot tape measure
      Measuring tape
    • hammer
      Hammer
    • nailset
      Nailset
    • four-foot level
      Level
    • drill
      Cordless drill
    • utility knife
      Utility knife

    Shopping List

    Close
    1. 3/4-INCH VENEER PLYWOOD

    Calculate how many 8-foot-long boards you can get from one sheet and use that to figure out how many sheets you will need to get enough board feet. (A plywood sheet is 4 feet wide, but keep in mind that a saw blade takes off 1/8 inch per rip.) You’ll need at least 3 sheets for a 4-by-8-foot bookcase.



    2. 5/4x4 TRIM

    for masking plywood edges around the perimeter of the bookcase front. Measure the length of the two legs, plus the width of the case, then add 10 percent for waste.



    3. 1x TRIM

    to make nosing for the front of the shelves. For more support, use thicker stock. Take the length of one shelf and multiply it by the number of shelves (including the bottom shelf). Add 10 percent for waste.



    4. YELLOW WOOD GLUE

    5. 1-INCH DISPOSABLE BRISTLE BRUSH

    for applying glue neatly to plywood edges



    6. 1 1/4-INCH (3D) FINISH NAILS

    for nailing the supports in place



    7. 2-INCH (6D) FINISH NAILS

    for nailing trim in place



    8. 1 5/8 and 2 1/2-INCH WOOD SCREWS

    9. SHIMS

    or leveling the bookcase



    10. WOOD PUTTY OR WAX PENCIL

    in a color to match the wood, to fill nail holes



    11. STAIN OR PAINT

    12. BUTCHER'S WAX OR POLYURETHANE