Step 6: Rip the plank to width

Cutting the plank
Photo: Kolin Smith
«»
Use a jigsaw to rip the plank to width and to cut the doorway notches, above center. Cut the plank so it fits underneath the casing and reaches the doorstop. Use a fine-tooth wood blade, and cut slowly.
Next

Related Content

Contribute to This Story Below

Add Comment

    More in Flooring

    Tools List

    Close
    • power flush cut saw
      Flush-cut dovetail saw,
      to trim door casings
    • miter saw
      Miter saw,
      for cutting flooring and molding to length
    • jigsaw
      Jigsaw or circular saw,
      to rip flooring to width
    • hammer
      Hammer and nail set,
      for tapping planks together and installing molding
    • flat prybar
      Flat bar,
      to pry last plank into place
    • coping saw
      Coping saw,
      for coping molding's inside corners

    Shopping List

    Close
    1. ENGINEERED WOOD FLOORING

    sold in bundles of 11 to 30 square feet. Calculate the square footage of the room, then add 10 percent to account for off-cuts



    2. FOAM UNDERLAYMENT

    sold in 3- or 4-foot-wide rolls



    3. DUCT TAPE

    to seal foam underlayment seams



    4. 5/16-INCH SPACERS

    to create expansion gaps between flooring and walls



    5. GLUE

    use only the type recommended by the flooring manufacturer



    6. PAINTER'S TAPE

    7. TRANSITION MOLDING

    8. QUARTER-ROUND SHOE MOLDING

    9. 1 1/2-INCH (4D) FINISH NAILS

    for attaching shoe molding