Step 10: Check the fit

CHECKING THE FIT
Photo: Kolin Smith
«»
After completing the coped cut, test-fit it against the square-cut crown that's nailed in place.

If necessary, use a rasp to remove more wood or smooth out the coped cut.

Nail the coped molding in place and set the nails.

Next

Related Content

Ask TOH users about Crown Molding
Discuss

Contribute to This Story Below

Add Comment

    More in Molding & Carpentry

    Tools List

    Close
    • miter saw
      Power Miter Saw,
      rents for $30 to $50 a day
    • coping saw
      Coping Saw,
      for shaping inside corners
    • chalk line
      Chalk Line,
      to creat a reference line on a wall with an uneven ceiling
    • hot glue gun
      Hot-Melt Glue Gun,
      to glue a temporary fence to the saw
    • rasp
      Rasp,
      for smoothing coped joints
    • drill
      Drill/driver,
      to predrill nail holes where molding is prone to split
    • hammer
      Hammer and Nailset,
      or rent a pneumatic nail gun and compressor for $30 to $40 a day

    Shopping List

    Close
    1. Crown molding

    To get the number of linear feet you need, measure the perimeter of the room, then add 15 to 20 percent for cut-off waste and errors



    2. 4d finish nails

    3. 6d or 8d finish nails

    4. Polyurethane glue

    (or yellow carpenter's glue, which cleans up more easily but isn't as strong on the end grain of a miter cut)



    5. Wood putty

    6. Paint or stain