«»
Enlarge image to see the Stages of Assembly.
Overview
Introduction
Overview
Step 1
Lay out the partition
Step 2
Mark the plates
Step 3
Measure the studs
Step 4
Cut the studs
Step 5
Assemble the pieces
Step 6
Tilt up the partition
Step 7
Check the partition for plumb
Step 8
Secure the partition
Step 9
Zigzag Blocking
«»
Enlarge image to see the Stages of Assembly.
More in Framing & Insulation
Tools List
-
Level,
for checking whether studs are plumb -
Sledgehammer,
for nudging the sole plate into position -
Framing square,
for marking cut and layout lines -
Tape measure
-
20-oz. framing hammer
-
Chalk line,
for marking location of wall on floor and ceiling -
Plumb bob,
for aligning layout marks between ceiling and floor -
Speed Square,
for marking plates, headers, and studs, and as a saw guide -
Circular saw
Shopping List
1. 2x4s
2. 10D AND 16D COMMON NAILS
2. 10D AND 16D COMMON NAILS
Contribute to This Story Below