Overview

installing clapboard siding illustration
Illustration by: J. Taylor
«»
PLANNING AHEAD

•To estimate the amount of stock needed for a siding job, measure the height and width of all the walls to get the total square footage of the surface area. Then deduct the area of all the doors and windows. Take that measurement to the lumber yard, where, based on the width and exposure of the siding you want, they will determine the number of linear feet you need.

•Click "enlarge this image" to view illustration labels.
Next

Related Content

Ask TOH users about Siding
Discuss

Contribute to This Story Below

Add Comment

    More in House Exterior

    Tools List

    Close
    • speed square
      Speed Square,
      for marking story pole and swing stick
    • chalk line
      Chalk line.
      for premarking courses and for finding and marking plumb lines at stud locations
    • utility knife
      Utility knife,
      for notching clapboard and cutting felt, flashing, and waterproofing membrane
    • tacker hammer
      Hammer tacker and staples,
      for attaching builder's felt to sheathing alternative: staple gun
    • 16-foot tape measure
      Tape measure
    • caulk gun
      Caulk gun with paintable, synthetic-rubber sealant,
      for sealing ends of clapboard at casings, frieze, and corner boards
    • ladder
      Ladder or scaffolding,
      for reaching high spots
    • miter saw
      Miter saw,
      for cutting clapboards to length
    • hammer
      Hammer
    • table saw
      Table saw,
      for ripping down the starter strip

    Shopping List

    Close
    1. PRIMED RED-CEDAR CLAPBOARD

    2. BUILDER'S FELT: 15-POUND, 12-INCH-WIDE ROLL

    for protecting sheathing at water table, corner boards, and around window and door casings



    3. BUILDER'S FELT: 2-INCH-WIDE ROLL

    for covering the wall at stud locations



    4. METAL FLASHING

    for covering the top edge of the water table and window casings



    5. WATERPROOF MEMBRANE

    for protecting the tops of windows and doors



    6. 4D AND 7D STAINLESS STEEL RING-SHANK NAILS

    for attaching clapboard and flashing