Overview

Entryway Before
Photo: Ryan Benyi
«»
Entryway Before

Budget: $250 to $500
Key players: Entry set, knocker, kickplate
DIY savings: Up to $250 to hire a locksmith

How to Pick a New Entry Set
The key to an easy entry upgrade is finding a handle-and-lock assembly that lines up with your door's existing drill-outs. Follow these guidelines to ensure that your new set will be a perfect fit.

Lock type
There are two options: A tubular lock, which installs in two holes in the door, and a mortise lock, which goes in one hole. Tubular locks are more widely available, easier to install, and less expensive. Mortise locks, which tend to be more solidly built, require a locksmith to install. Unless you plan on buying a new door, make sure your new setup has the same lock type as the old one. Also, check the dimensions of the strike plate to ensure it will fit in the existing impression in the door jamb to avoid having to pull out a chisel.

Door swing
Entry sets with handles or knobs can typically be adapted to a right- or left-hand door swing, but ones with levers are not so forgiving. To determine if your door has a right- or left-hand swing, stand outside and note which side the hinges are attached to. A door that is hinged on the left side, for instance, swings to the left.

Hole placement
Remove the interior knob and thumb-turn lock hardware to expose the holes in the door. Measure from the center of the knob hole to the center of the lock hole to determine the spread. On a replacement set with a one-piece exterior escutcheon that holds both the lock cylinder and latch, the spread must match the holes exactly. Choose a two-piece set if you want more wiggle room. Measure the backset: the distance from the inner edge of the door to the center of the knob and lock holes. Backsets are typically either 2 or 2¾ inches. With the door closed, the new escutcheon or rosettes should fully cover the holes, leaving at least ¼ inch between their outside edges and the doorstop.
Ask TOH users about Doors

Contribute to This Story Below

    Tools List

    • multi-bit screwdriver
      Screwdriver
    • hex keys
      Hex key
    • drill
      Drill/driver

    Shopping List

    1. Entry set

    2. Knocker3. Kickplate